Cupholder is awesome, good 3d printing. I great solution to the Cupholder.
Thank you so much :)
The product is fine however I ordered the Standard which didn’t come with the back compartment leaving the rest of my center piece open and your website doesn’t offer just the back compartment which I sent an email to you guys asking if you sell just the back piece but I haven’t got an email back yet
Should've orderd the MAX in the first place! lol
We didn't received any mail so far, try again with this address
rendition36@gmail.com
We will ship you a rear part no problem
I like them a lot, they add a nice touch to the interior, They are a little smaller than expected but no issues
We're glad you like them. Can you message us and tell us what part is smaller? We are more than happy to send you a replacement if theres something wrong with our product.
I have y revive my order
So obviously, this is a 3-D printed product. It was supposed to come in one piece but my piece came separated in the mail. I guess the glue didn't hold up but that actually worked out for the better because I inserted an eighth of an inch piece in the middle to make the whole fit a little bit more tight. I also went ahead and glued that little divider in because every time I put something in and out it would knock it out of its slots. Screw lines of perfectly with a hole in my car. I just needed to get a threaded clip and a long enough screw and I was all set.
